Planet-technology ENW-9607/9607M Manual de usuario

1 64-bit PCI Gigabit Ethernet Network Adapter ENW-9607/9607M User’s Manual Version 1.0

7 5. Select “Specify a location” and click “Next”. 6. You can click “Browse” to specify the driver location. (Assume "E" is your CD-RO

8 9. Please click “Finish” to complete the driver installation. (In Win98/Me, Windows will ask you restart your PC when driver installation

9 4. Please select “Include this location in the search” and then click “Browse” to specify ENW-9607M driver location to install. (Assume "E

10 3.3 Installing Driver To Windows NT 1. Install ENW-9607M into your PC’s PCI slot. 2. Power on the PC and insert Driver Disk into CD-ROM drive. 3.

11 and start the build process with the following command: # cd DriverInstall # ./install.sh 4. Choose your favorite installation

12 Chapter 4 Utility ENW-9607 is VCT Technology supported. The Virtual Cable Tester(TM) installation package contains the Marvell Virtual Cable Teste

13 3. Please check the installation note and click “Next” to continue. 4. Please click “Install” to begin the installation. 5. Please click “Finis

14 your PC, please select the card you want to test in the first field. Then click “Run” button to test the cable status of selected ENW-9607.

15 Chapter 5 Specifications Model ENW-9607 ENW-9607M Standards IEEE 802.3 IEEE 802.3u IEEE802.3ab IEEE802.3ab Connectors RJ-45 Mini-GBIC LEDs 100

16 Appendix A Advanced Properties The default settings of the adapter should work in most cases. However, if you experience any unusual circumstances

2 Copyright Copyright  2004 by PLANET Technology Corp. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed

3 Table of Contents CHAPTER 1 INTRODUCTION...1 1.1 PACKAGE

Chapter 1 Introduction The ENW-9607 is a 64-bit 10/100/1000Base-T PCI 2.2 Gigabit Ethernet adapter designed to address high-performance system applica

2 1.3 Verifying Your System Requirements Before installing the ENW-9607/9607M, be sure your computer meets the following requirements: Hardware ü CP

3 Chapter 2 Hardware Installation 2.1 LED definitions The faceplate of ENW-9607 has four LEDs: 100, 1000 FDX and ACT. And ENW-9607M has three LEDs: 1

4 LED Description 100 / 1000 Off/Off: Works with 10Mbps On/Off: Works with 100Mbps Off/On: Works with 1000Mbps FDX Off: Works in Half-Duplex mode On

5 Step 7: Replace the PC cover. Step 8: Power on the PC and refer to next chapter to install the driver of this adapter. ? Note: Please do not ins

6 Chapter 3 Driver Installation A device driver must be installed before your ENW-9607/9607M can be used with your computer. This chapter describes h