Planet-technology VIP-320 Manual de usuario

H.323/SIP DECT VoIP router VIP-320 User’s manual 1

Overview of DECT handset DCT-100 Keypad and button definition on DCT-100 Descriptions INT Intercom conversation mode Adjust the volume level d

11 Reversing the orientation may damage the handset.  The battery needs to be replaced if it does not recoverits full storage capacity after rech

12• Select the desired DECT base (Base1 for example). Press INT key, DCT-100 will display Searching: on the LCD screen • Wait till a machine hardwa

2Chapter 2 Preparations & Installation Physical Installation Requirement This chapter illustrates basic installation of VIP-320 • Network cables.

Please locate your PC in the same network segment (192.168.0.x) of VIP-320. If you’re not familiar with TCP/IP, please refer to related chapter on

It is suggested to keep the DHCP server related parametersin default state to keep machine in best performance. L Hint After confirming the modi

16

3 Chapter 3 Network Service Configurations Configuring and monitoring your VIP-320 from web browser The VIP-320 integrates a web-based graphical user

VIP-320 main page 18

Chapter 4 VoIP Configurations VIP-320 Status This page main display the current and last time VoIP call status & result. Parameter Description PC

Copyright Copyright (C) 2005 PLANET Technology Corp. All rights reserved. The products and programs described in this User’s Manual are licensed pro

Server” Error Message: For some reason (ex. All lines of this VoIP router are busy), here will display the failure information of last time VoIP Call

number. That mean it will direct call out by VoIP when you off hook the phone of this line. Tone Config This page defines the tones generated to th

VoIP Call Out This page defines the routing rule for Call out to VoIP. (User key in the phone number through phone set dial pad, the

23is a compare order rule on this routing table. That mean the VoIP router will check the rule list from top to bottom one by one, any rule item matc

number will be 0,22199518 ( “, “ mean wait 1 second). This example is especially for speed dial function. Profile Define the optional special call out

25 Parameter Description Area Code Define the Prefix number this rule service, any VoIP called from network dialed number prefix digits matched with

26Server Assign which gatekeeper to authorize this incoming VoIP call before call out. For example, if the dial number should be checked by server 1

Please remember to press the modify button to take it effect. For store back to flash memory, please press “Save Modification” (Plaase refer

OFF: FAX over IP is disable. Package Frame Select the voice payload frame on each UDP package VoIP transmit. More frames into one package is save more

 No answer Please add a profile at “VoIP Config  Call Routing  Call Setup” and put the name of profile on the Call out Routing table (Please refer

3Revision User’s Manual for PLANET H.323/SIP VoIP Router: Model: VIP-320 Rev: 1.1 (September, 2005) Part No. EM-VIP320V1

30Register Server If this VoIP router want to use GK/SIP proxy service to transfer the VoIP call, you can input the GK /SIP information here. The VoI

When voice communication is established via H.323 protocol,please add a ”h323:” in front of the IP address. Such as: the GK IP addre

32Parameter Description Gateway IP Show the IP of this VoIP router Name Select the name you want to make connect, this is defined on Web Call page. (

name, please rename your logo graphic file(.bmp, .jpg, .gif) to “Welcome” before upload. There is a file size limitation. Please press the Browse butt

34The Default User name is “admin” and the password is “123”from factory. Press RESET button on rear panel over 5 secondswill cause the VoIP router r

LAN-to-WAN Access Rules: You can define LAN-to-WAN network access rules which evaluate the network traffic's source IP address, destination IP ad

36 The ability to define network access rules is a verypowerful management tool. Using a custom rule, it's possible to disable all firewall pr

37When any change is made on this page, you MUST restart allPCs to update their TCP/IP settings from this DHCP server.Adding incorrect routing inform

38Virtual Server This page allows you to map a TCP or a UDP port of the router to a host which actually deals with requests on the private network.

39System Maintenance This page let you backup / Restore all of your configuration parameters on the VoIP router. It is very good idea to back up all

4Chapter 1 ... 6 Introduction...

40 Reboot System Use the Reboot button on this page to reboot your VoIP router, before you reboot, please make sure you have to press the “Saved modi

Chapter 6 DECT Handset Operations In machine default state, the DECT handset DCT-100 is registered with VIP-320. When adding more DECT handsets to the

2.2 DECT Screen Display This area displays in-use information such as the caller's number, menus, call duration, etc. In standby mode, the displa

Note: x is the registered handset number and y is the registered DECT base. Un-register / Reset your DCT-100 • Press the INT button before power on

BS setting Base setting is using for factory mode, after modify BS setting, please restart the base! Factory default PIN is 1590 / Pr

become annulment! 2. Press ② button to show [EW361001] (Firmware) This setting is to show the base firmware version. Press * button and the displa

6. Press ⑥ button to show option code 7. Press ⑨ button to select [BARRING] The base can setting barring number, if the first-part digits of dia

Appendix Appendix A Voice communications There are several ways to make calls to desired destination in VIP-320. In this chapter, we’ll lead you step

When the calling party is an H.323 device, please add a ”h323:” in front of the IP address. Such as: the destination H.323 device is 172.16.0.100, th

When voice communication is established via “Gatekeeper”,please add a ”h323:” in front of the IP address. Such as: the GK IP address is 192.168.0.1

5DHCP Server Setting...37 Static Routing ...

STEP 4: Repeat the same configuration steps on the VIP-280, and check the machine registration status, make sure the registrations are completed.

51Appendix B VIP-320 Specifications Product H.323 / SIP DECT VoIP Router Model VIP-320 Hardware LAN 2 x 10/100Mbps RJ-45 port WAN 1 x 10/100Mbps

6Chapter 1 1 Introduction Overview With years of Internet telephony and router manufacturing experience, PLANET proudly introduces the newest membe

7• Voice processing: Voice Active Detection, DTMF detection/ generation, G.168 echo cancellation (16mSec.), Comfort noise generation, Call progress

8Physical Details The following figure illustrates the front/rear panel of VIP-320. Front Panel of VIP-320 Rear Pane

9LED Display & Button Front Panels Descriptions Paring LED When the base connect to the handset Battery Charge When charging the handset’s b