Planet Technology IAD-200W Manual de usuario descargar pdf (Pagina 15)

2. Connect LAN Cable

Use the supplied LAN cable to connect the LAN port on the IAD-200 / IAD-200W to

your hub.

3. Connect ADSL Cable

Connect the supplied ADSL cable from the ADSL port on the IAD-200 / IAD-200W to

the ADSL terminator provided by your phone company.

4. Connect PSTN Line

Connect the PSTN socket on the rear of the IAD-200 / IAD-200W to your normal phone

line socket.

5. Connect Phone

Connect a standard phone to the Phone socket on the rear of the IAD-200 / IAD-200W.

6. Power Up

Connect the supplied power adapter to the IAD-200 / IAD-200W. Use only the power

adapter provided. Using a different one may cause hardware damage.

Power up by pressing the rear-mounted power switch IN, and wait for startup to be com-

pleted.

7. Check the LEDs

• The Power LED should be ON.

• The Status LED should flash, then turn Off. If it stays on, there is a hardware error.

• Either the 100BT or 10BT LED should be ON.

• Phone LED should be OFF.

• PSTN LED will be OFF.

• WLAN LED should be ON (IAD-200W only).

• ADSL LED should be ON.

• Internet LED will be OFF.

It will come ON when configuration is complete and correct, and an Internet connec-

tion is established.

For more information, refer to Front-mounted LEDs in Chapter 1.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 110 111

Sin comentarios

Planet Technology IAD-200W Manual de usuario Pagina 15